This property contains the value of the RS interfaces fixed baud rate. Don’t see a manual you are looking for? IntelliStripe Command Reference Of course the operation requested may complete without encountering any abnormal situations at all. Page 95 Section This property specifies an audible tone that may be played when the host chooses.

Uploader: Shajora
Date Added: 28 September 2018
File Size: 45.60 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 10283
Price: Free* [*Free Regsitration Required]

A card must be present at the middle or rear of the transport when this command is executed in order for it to succeed.

MAGTEK | Intellistripe – Desktop Motorised Card Reader

This application works closely with the transport application, which deals with card transportation and magnetic stripe data acquisition. Not all device applications support these commands.

A Clear Data command is issued. Your manual failed to upload The first are ISO Microprocessor cards.

Intellistripe 320

If the bit corresponding to an indicator is set, then a notification message will be sent from the device to the host in response to that indicator changing from a 1 to a 0 state. Page lntellistripe IntelliStripe Command Reference Of course the operation requested may complete without encountering any abnormal situations at all.


A generic result code has a common meaning for different device applications. General Properties used by the whole application. Page 45 Section 5. Track 1,2,3 only Smartcard Functions: P2 is the address where the write will start Lc is the number of bytes to write. Your message has been sent. When this property is disabled, the device will no longer require the host to perform the auto baud synchronization sequence. We give an access to everything buyer need at competitive prices.

These commands are used to retrieve and set the value of application properties.

Intellistripe 350

This command is used to get decoded information related to a magnetic stripe read for a single track. IntelliStripe Command Reference The following result codes are defined: Page 17 Section 3. The IntelliStripe is rugged and corrosion resistant, matgek a zinc die-cast chassis, high-impact plastic bezel, and stainless steel components.

Note that some versions mmagtek this reader can only read track 2 for this format. This property is used control notification messages sent in response to a transport indicator changing from a 1 to a 0 state. The message format and contents are independent of the transport mechanism by which the messages are exchanged.

Page 49 Section 5. Each template is 4 bytes long. A 4 byte ATR is returned when the power up command is successful. The existence of generic commands allows standardizing on commonly used commands across multiple device applications. It can withstand a wide range of operational and environmental conditions, and is the ideal motorised card reader for ATMs, vending machines, or self-service kiosks.


The Data consists of a 1-byte command Number Op Code and optional data bytes. Samsung and Qualcomm phone prototypes tease our 5G future But you still have to wait for the real thing.

MagTek IntelliStripe : Manual

This property enables or disables MCP auto baud synchronization. This command is used to power down a smart inrellistripe in the currently selected connector.

Only valid property types are returned. This device will send all responses within 5 seconds. This command attempts to consume a card into the transport to a position where smart card communications can occur and magnetic stripe reading is complete.